September 2015

Then, my job is Karnival Keusahawanan Desa at Presint 3 Putrajaya. Here i was assigned as CCU's system assistant. I helped Mr Andy to setup the MCP system to give camera feed for RTM. The call time is at 8:00 am. We arrived at the location and setup at our position beside Operating Base Truck's RTM. I lay the TRIAX cable from the CCU system to Jimmy Jib Crane's Camera to send the video signal. The cable length is about 500 meter from the system to the Jibs. After the layer been done, i helped Mr Najmee setup the Jimmy Jib's Crane to be used at the opening ceremony. After that, the event started where Datuk Seri Najib was the guest. We cover when the arrival and during Prime Minister's speech. The event take about 2 hours and then we start our wrap session at 4:00 pm. After all the cable been roll to the drum's and all the equipment have been wrap we wait the lorry to come. We load the equipment in the lorry and go straight to Jelas Juta Sdn. Bhd.

Next, the job is been held in Pulau Pinang. I was assigned as Jimmy Jib assistant for Mr Megat. This is the first job I do outside Kuala Lumpur and Selangor region. We start our journey one day earlier. We convoy with a 2 lorry, 3 van and 2 car. The event is for the Indian's concert Jodi No.1 that been held in Spice Badminton Stadium. We arrived there after 4 hours driving from Kuala Lumpur. After we reached there, i helped the crew to load out the equipment from the lorry to be placed in the control room. Then we go to the condo that we rent to rest. The next day, we go back to the location and started our setup. I helped Mr Megat to setup the Jimmy Jib's crane. After the Jib's was setup, I lay the cable from the control room to the camera. The cable was lay through the cable path. The Jimmy Jib's crane this time is a little bit different than the others because we add the dutch head at the camera. So the camera can be used to tilt and pan 180 degrees. So the shot will became dynamic and suitable for a concert that really loud and enjoyable. When the event was held i sat in the control room and check on the AJA system that recording the hold program to the hard disk driver. Im gonna make sure the recording was on and record the whole event and how many percentage of the hard disk has been used also have to been check up time to time. After the 3 hours event we finally came to the end of the event. Its a wrap time, we clean and pack our equipment and load in the lorry. The wrap session take about 2 hours more because to transfer the recorded event from the AJA to the hard disk take about an hour and a half. After the transfer was done, we head straight to Kuala Lumpur and arrived at 7:00 am. This job is really tiring but really enjoyable. Its a tremendous experience for me and was fortunate to join the job with a great team.

                                   

 

          

          

         

       

      

After that, my next job is at Studio 4 Bangsar to do a game show recording named Tempur Gempur for RTM. We arrived at the location a day earlier to setup our gear and equipment. The setup been delayed for about 2 hours because of the vendor for the stage and the lighting face a difficulties because of the studio's location that a little bit far from the road. So they have to unload their equipment such as play wood and board far from the studio. After a bout 2 hours we finally can setup the MCP unit and put the camera in position. Then we layered the cable safely through the path and route. The next day we arrived at 7:00 am. We had breakfast and the shooting was delayed because the artist shown up late to the location. After that, we started to record the game show. I was assigned as AJA Operator where i make sure the game is recorded and make sure the percentage of space that been used in the AJA hard disk. As a conclusion, I learn that its either you are famous or not, when u are committed to the job you have to be professional about your calling time because it can effect the whole recording schedule.